Joerg
Joerg
About
- Username
- Joerg
- Joined
- Visits
- 0
- Last Active
- Roles
- Members
Comments
-
Addendum: It seems to be associated with wordwraps within memos above. In 3.20 it works fine. Joerg
-
THX very much! it works fine!
-
THX, but the page height can't be changed, because off there is no property. Why can't I set the height property of the Masterdata Band greater then the (print)page or paperheight ? Example: in fr 3.18 : page1.paperheight is 21 cm, MasterData…
-
Hi, yes, I use BCB too and I've had the same problem too. There is an error in the BCB 3.19 installation setup. I removed the the packages dcl.. and created the packages frxTee6.bpl and fsTee6.bpl by myself. The project files are in the \LibBCB6…
-
THX for prompt answer, But, no, the page ist not the problem, the property is true. The height of the masterband can not be changed. In 3.18 it works! If I open the fr3 file in 3.18 the bottom borderline of the band is below all masterdataelemen…
-
Hi again, My last posting was a little bit confuse - I use C++Builder6 formost... I tried the Delphi7 Fastreport 3.12 Standard with TCPro7.04 too. But this works without patching the fs7 or frx7.dpk files. I started the recompile.exe and set …
-
Hi, I had the same problems with C++ Builder 6. Change two project files fsx.dpk and frxx.dpk: All Tee7 or Tee6 to Tee7C6. Then recompile with fastreport recompile.exe all packages. Be sure, that there are no old Tee Libs and other old tee files i…
-
THX, I think this was the light for the black hole....
-
BPI/LIB files are only used with C++ Builder. If you have this IDE and the TeeChart Pro 7.0x for C++ Builder 6 you have this BPI Files (LIB Directory of Steema or CBB (LIB\OBJ) Joerg
-
Thanks for the support... It's been solved. Joerg
-
Thanks for your answer, yes, after change frx6.bpk it works. But before fs6.bpk has to change! Thanks again, think we'll use your product...
-
Additional question: If I want to buy FR 3 Standard CB6, must I recompile FR, if I've installed Teechart Pro 7.03? Joerg