Band Height - Designer

Comments

• -=Den=-

  October 2005 edited 10:16PM

  "Page Options"->"Other Options"->"Large hreight in desing mode" must be set.
• Joerg

  October 2005 edited 10:16PM

  THX for prompt answer,
  
  But, no,
  the page ist not the problem, the property is true. The height of the masterband can not be changed. In 3.18 it works! If I open the fr3 file in 3.18 the bottom borderline of the band is below all masterdataelements, in 3.19 (same project)above and it's height can not be changed.
  
• -=Den=-

  October 2005 edited 10:16PM

  Change size of the page or use ChildBand.
• Joerg

  November 2005 edited 10:16PM

  THX,
  
  but the page height can't be changed, because off there is no property. Why can't I set the height property of the Masterdata Band greater then the (print)page or paperheight ?
  Example:
  
  in fr 3.18 : page1.paperheight is 21 cm, MasterData1.Height is 41,3 cm (can be changed)
  
  The same fr file after open and click somewhere into the design:
  
  fr 3.19 : page1.paperheight is 21 cm, MasterData1.Height is 18,5 cm ( and can not be changed). Why?
  Joerg
• -=Den=-

  November 2005 edited 10:16PM

  Maximum height of Band = PaperHeight - TopMargin - BottomMargin