TfrxDMPCommand Object

Comments

• hirasoft

  September 2006 edited 7:24PM

  I could locate this object on designer.
  I placed this object on page. (It is a dot matrix report)
  Now I want to specify page length in lines.
  so in command properties of this object, I specified
  Chr(27) + "C" +Chr(36)
  and expecting that it will set the page lenth as 36 lines.
  When I tried to print, it flashes an error
  $Ch is not integer value
  How to specify such commands?
  printer manual says that escape sequence + upper C + chr of number lines must be sent to printer.
• alman

  July 2007 edited 7:24PM

  hirasoft wrote: »

  I could locate this object on designer.
  I placed this object on page. (It is a dot matrix report)
  Now I want to specify page length in lines.
  so in command properties of this object, I specified
  Chr(27) + "C" +Chr(36)
  and expecting that it will set the page lenth as 36 lines.
  When I tried to print, it flashes an error
  $Ch is not integer value
  How to specify such commands?
  printer manual says that escape sequence + upper C + chr of number lines must be sent to printer.

  
  If you create a DotMatrix report then PageHeight and PageWidth properties of TfrxDMPPage object describes the page size in characters. So, you don't need send Esc sequences directly to the printer.