Major and Build Version

Comments

• gordk St.Catherines On. Canada.

  September 2004 edited 2:26AM

  hi marcos
  they are saved for me in fr3 pro
  from either report options dialog
  or obj inspector reportoptions
  you must save on way out of designer.
  or do you mean that fr2.53 is not exporting those values to the fr3 format when converting.
  
• prmas

  September 2004 edited 2:26AM

  Gordk,
  
  I created a new report in fr3 and saved. When I needed to have access these information, I perceived that they had not been recorded. I made the tests and I evidenced the error.
  
  I also tested with other reports and occurred problem the same. I am using of fr3 pro.
  
  How I must proceed? Necessary of these information.
  
  Regards,
  
  Marcos
• AlexTZ

  September 2004 edited 2:26AM

  I cannot reproduce this, works well for me too. Can you tell step-by-step instructions?
• prmas

  September 2004 edited 2:26AM

  Alex, I perceived that the error alone occurs when modified the two values.
  It follows the steps below:
  
  1 - In fr3Demo, it selects the report "List" e click in "Designer".
  2 - Selects the Menu "Report/Options".
  3 - In the border "Description" version" modifies the values "Major/Minor
  4 - Click in the button "Save" end Exit
  5 - selects another report to clean the memory.
  6 - It again selects the previous report and click in "Designer".
  7 - Click in the Menu "Report/Options", in the border "Description" e sees that the values had not been recorded.
  
  The times record do not know because, but in the majority of the times it is not recording.
  
  Regards,
  
  Marcos