Major and Build Version

prmas

Options : "Major and Build Version" of "Report Settings/Description", they are not recorded in the report.

Marcos

gordk

hi marcos
they are saved for me in fr3 pro
from either report options dialog
or obj inspector reportoptions
you must save on way out of designer.
or do you mean that fr2.53 is not exporting those values to the fr3 format when converting.

prmas

Gordk,

I created a new report in fr3 and saved. When I needed to have access these information, I perceived that they had not been recorded. I made the tests and I evidenced the error.

I also tested with other reports and occurred problem the same. I am using of fr3 pro.

How I must proceed? Necessary of these information.

Regards,

Marcos

AlexTZ

I cannot reproduce this, works well for me too. Can you tell step-by-step instructions?

prmas

Alex, I perceived that the error alone occurs when modified the two values.
It follows the steps below:

1 - In fr3Demo, it selects the report "List" e click in "Designer".
2 - Selects the Menu "Report/Options".
3 - In the border "Description" version" modifies the values "Major/Minor
4 - Click in the button "Save" end Exit
5 - selects another report to clean the memory.
6 - It again selects the previous report and click in "Designer".
7 - Click in the Menu "Report/Options", in the border "Description" e sees that the values had not been recorded.

The times record do not know because, but in the majority of the times it is not recording.

Regards,

Marcos