Register Fastreport3.dll in Windows Vista

Comments

• HERBERTS

  December 2007 edited 2:04PM

  what error message do you get ?
• tcrous

  July 2008 edited 2:04PM

  HERBERTS wrote: »

  what error message do you get ?

  
  
  If you try to start up the Designer I get a COM error: "Class not registered". What is going on here - I don't think FR can run on Vista, I bought version 4.6.64.0 and it doen't work!
• Raleigh

  August 2008 edited 2:04PM

  tcrous wrote: »

  tcrous wrote: »

  what error message do you get ?

  
  
  If you try to start up the Designer I get a COM error: "Class not registered". What is going on here - I don't think FR can run on Vista, I bought version 4.6.64.0 and it doen't work!

  
  
  Yeah, same here... I'm using Vista and getting the same COM error... any response from Fast Reports Inc.?
  
  Thanks
• hmdfar

  September 2008 edited September 2008

  Hello,
  
  in install it and get this error messages
  

  access violation at address 01CF69AF in module 'fastreport3.dll'. Read
  of address 00000008.
  

  and
  

  Class not registered.
  
• alman

  November 2008 edited 2:04PM

  Some problems may arise in case of Windows Vista UAC (User Access Control) is disabled on installation stage.
  Even you don't need UAC, you must enable it on installation procedure. You may disable it after installation procedure.
  
  Also you can register DLL manually by following command in command prompt:
  
  regsvr32.exe "C:\Program Files\FastReports\FastReport Studio\Bin\fastreport3.dll"
  
  Please note that this command must be executed with Administrator priveleges.
  
  As I remember, under 64-bit version regsvr32 does not properly register fastreport3.dll. Under 64-bit environment you need to use Studio MSI installer.