printing 8-inch forms (dotmatrix)
diasw
Germany
Hi there,
I want to print on a dot-matrix printer a form which is 8 inches high, fanfold paper.
I set the pagesettings hight to 48 Characters (6 lpi), but it seems to me as if Fast-report ignores this value in printing (in the design- and preview-output the sheet is shown with 48 chars hight). with pagebreak enabled it prints and the printer start formfeed and continue printing after 12 inches (=normal paper). With pagebreak disabled it prints the next page not correct (there is an offset of about 2 lines).
What do I have to tell Fast-Report to send the pagesettings correct to the printer?
regards
Sascha
I want to print on a dot-matrix printer a form which is 8 inches high, fanfold paper.
I set the pagesettings hight to 48 Characters (6 lpi), but it seems to me as if Fast-report ignores this value in printing (in the design- and preview-output the sheet is shown with 48 chars hight). with pagebreak enabled it prints and the printer start formfeed and continue printing after 12 inches (=normal paper). With pagebreak disabled it prints the next page not correct (there is an offset of about 2 lines).
What do I have to tell Fast-Report to send the pagesettings correct to the printer?
regards
Sascha
Comments
for the printer
see the page properties for the printer in the system settings.