Fastreport 5 and dot matrix

edited February 2016 in FastReport VCL 5
Hello,

I have one report designed good and prints out good pre-printed paper on laserjet printer, but when I switch to dot matrix (okidata microline 320) all alignments messes up, some up and some down on same pre-printed paper.

any idea what I need to fix or to do to fix this issue?


Thank you

Comments

  • gordkgordk St.Catherines On. Canada.
    edited 11:28PM
    Generally you should design a dot matrix report for dm printers or run the printer in graphics mode very slow
    add the frxDMPExport to your project and read the Usermanual chapter on dotmatrix reports
  • edited 11:28PM
    What should i do to print a frx report using a dot matrix printer (Epson LX-300+ II)? This report was designed using Fastreport.Net Version 2017.1.17 and the preview is ok but the printout is so ugly. I tryed different fonts types, changing all and each printer parameters, updating the printer driver and nothing works.

    Thanks in advance
  • gpigpi
    edited 11:28PM
    robelope
    For FR.Net you should select export to text file option and then print exported report
  • edited 11:28PM
    Could you please tell me if there are some manual with detailed information about all the parameters/options i could use in this process?

    I need to use PrinterCommands to change the font size and other stuff in order to match a preprinted form.

    Thanks in advance
  • gpigpi
    edited 11:28PM
    This is FR VCL forum. See ticket #423809

Leave a Comment