How to send escape command for dot matrix
Hello every body
i have been struggling for two days just to send escape command to Epson POS Printer (epson TMU220)
i want the printer to cut the paper after it finished printing. the Esc Command for cutting papaer is ESC + i
so i put tfrxDMPCommand at the end of band area and set the command property to #27#105
but still nothing happened...even though then i tried another escape command such make under line or italic,
the report still not responding to the frxDMPCommand.
i tried to send the escape command using raw print method and the printer respond to it normally.
please some body help to figure it out....
thanks in advance
i have been struggling for two days just to send escape command to Epson POS Printer (epson TMU220)
i want the printer to cut the paper after it finished printing. the Esc Command for cutting papaer is ESC + i
so i put tfrxDMPCommand at the end of band area and set the command property to #27#105
but still nothing happened...even though then i tried another escape command such make under line or italic,
the report still not responding to the frxDMPCommand.
i tried to send the escape command using raw print method and the printer respond to it normally.
please some body help to figure it out....
thanks in advance
Comments
please guide me
If this is a POS terminal the easiest way is to use a printer which is connected to the cash drawer. Opening the drawer sends a paper-cut signal to the printer.
You may have to send a paper cut signal from outside of the report.
@batozai Can you please help me on how you used the TfrxDMPCommand?
I can't find it in my installation.
I'm using Delphi 11
It is not there by designing the report? How do I drop it on the report?