Convertion problems
In the last version, there was a RoundRectangle control.
I've not found it in v3.
The closest control I've found is the ShapeView control (with a RoundRectangle frame attribute). This new control, if resized, modifies its round edge radius.
So if I want a large rectangle, its round edges are too big.
I used those RoundRectangle with text at the beginning, now the beggining of the text is out of the ShapeView.
Is there a solution to freeze the radius of the rounded edge of the rectangle?
I've not found it in v3.
The closest control I've found is the ShapeView control (with a RoundRectangle frame attribute). This new control, if resized, modifies its round edge radius.
So if I want a large rectangle, its round edges are too big.
I used those RoundRectangle with text at the beginning, now the beggining of the text is out of the ShapeView.
Is there a solution to freeze the radius of the rounded edge of the rectangle?
Comments