TreeView - ability to print
Howdy,
Is the ability to print a treeview available from FR 4?
I did a bit of searching (via our FR forums and the general net.),
and the only real lead I found is below (from one of this site's forums):
The above looks promising, but I haven't been able to locate
either this demo OR thread within the newsgroups ...
With the above in mind: Gordk: Could you possibly post this
demo somewhere? Either in a reply to this posting or (if your
time might permit) an email to me at: DbBanjo@Yahoo.Com?
Thanks,
Marc B.
Is the ability to print a treeview available from FR 4?
I did a bit of searching (via our FR forums and the general net.),
and the only real lead I found is below (from one of this site's forums):
there is a demo in the binaries newsgroup
printtreview it was produced in fr4.1.4
but you may be able to use the units and the dfms in fr3 project
![>](style_emoticons/<#EMO_DIR#>/wink.gif" style="vertical-align:middle" emoid=";)" border="0" alt="wink.gif" />)
The above looks promising, but I haven't been able to locate
either this demo OR thread within the newsgroups ...
With the above in mind: Gordk: Could you possibly post this
demo somewhere? Either in a reply to this posting or (if your
time might permit) an email to me at: DbBanjo@Yahoo.Com?
Thanks,
Marc B.
Comments
Got it - thanks for the fast reponse!
Thanks,
Marc B.
I appreciate the TreeView, print project\demo\concept you forwarded to me earlier.
With the above as a model, I was able to create a similar project using:
1. FR 4.14.3
2. D7 (Lol, yesss - some of us are still working with D7 ...)
3. Absolute db, ver. 7.05
The original TreeView demo used a temp, paradox back-end and I'm using (above)
an Absolute db, so attaching the entire project may not be too useful (ie: unless a
person is setup for a Absolute backend).
Despite the above, I have attached some screen shots showing:
1. Delphi code - I create a TList and assign the data to the UserDataSet via it's
OnGetValue event
2. FR Designer layout - simple layout (no grouping)
3. FR code - two events with dynamic parent & child node display logic done within
a single detail band event
4. Application TreeView (call to the rep)
5. FR rep. output - fairly close to display from 4.
Now the above is only used for a TreeView with 2 levels and I'M SURE there is better\easier
logic which can be used within the FR, but Lol - it's a start ...
Thanks,
Marc B.