Print report summary at end of page

Comments

• gordk St.Catherines On. Canada.

  September 2011 edited 12:09AM

  in the obp event of the summary band write code to force a newpage.
  engine.newpage
• mra

  September 2011 edited 12:09AM

  gordk wrote: »

  in the obp event of the summary band write code to force a newpage.
  engine.newpage

  ok i got the on bef print event i a applied the following code:
  
  Engine.NewPage;
  
  but the summary totals is printing on at a brand new page and not at the last page of the printing.
  
  any pointers.
  
  regars
  rashid.
• MariusJL

  December 2011 edited 12:09AM

  mra wrote: »

  mra wrote: »

  in the obp event of the summary band write code to force a newpage.
  engine.newpage

  ok i got the on bef print event i a applied the following code:
  
  Engine.NewPage;
  
  but the summary totals is printing on at a brand new page and not at the last page of the printing.
  
  any pointers.
  
  regars
  rashid.

  
  mra, did you ever get a solution for this? I need to do the same thing for an Invoice. There is ample space on the last page, but the summary is printed directly after the last detail instead of at the botton of that page.
• MariusJL

  December 2011 edited 12:09AM

  [/quote]
  
  mra, did you ever get a solution for this? I need to do the same thing for an Invoice. There is ample space on the last page, but the summary is printed directly after the last detail instead of at the botton of that page.
  [/quote]
  
  mra, if your'e interested I think i found the solution somewhere in the forum.
  
  Add this to your OBP event of the summary band
  
  Engine.CurY := Engine.CurY + Engine.FreeSpace - ReportSummary1.Height - 1;
• gordk St.Catherines On. Canada.

  December 2011 edited 12:09AM

  procedure ReportSummary1OnBeforePrint(Sender: TfrxComponent);
  begin
  if engine.freespace > reportsummary1.height then
  begin
  Engine.CurY := Engine.PageHeight -reportsummary1.height -pagefooter1.Height - 1;
  
  end;
  end;
  
  OR IF STRETCHING DO IT HERE
  
  procedure ReportSummary1OnAfterCalcHeight(Sender: TfrxComponent);
  
  begin
  Engine.CurY := Engine.PageHeight -reportsummary1.height -pagefooter1.Height - 1;
  end;
• Programmer

  December 2011 edited 12:09AM

  you can set it page place property to bottom